Steady Rollator & Wheelchair Carrier

The Steady Rollator Carrier 

• The carrier is adjustable from 19” to 26” wide and will accommodate most front to back folding walkers. 

• It extends approximately 12” from the hole in vehicle receiver.  Simply tilt the walker back on its front wheels and lower the rear wheels into the adjustable cradles, then push the walker forward, folding it, and fasten the spring loaded latch over the frame. 

• The Steady Rollator Carrier attaches to a vehicle in an inch and quarter  (1.25") receiver, allowing easy and secure transportation on cars, trucks, vans, SUV, ATCs,  golf carts and motorized scooters.

• The Steady Rollator Carrier is made of steel tubing and stainless seal hardware and weighs less than 9 pounds.  The Steady Rollator Carrier is made in Tennessee.  We are proud to say, “Made in the USA.”

The  Steady Wheelchair Carrier

• Attaches to your vehicle in an inch and quarter (1.25") receiver, allowing easy and secure transportation. 
  • To load, tilt the Wheelchair back on its large wheels and lower the front wheels into the basket, gently push the wheelchair forward and secure the handles onto the staff with the hook and loop strap.

• Also carries a standard or bariatric wheelchair, a transport chair, a side to side folding rollator walker or the up-right walker.

• The Steady Wheelchair Carrier is made of steel tubing and stainless seal hardware and weighs 15 pounds.

•  It extends approximately 22” from the hole in vehicle receiver.

• The Steady Wheelchair Carrier is made in Tennessee. We are proud to say, “Made in the USA.”